時間：2011-08-11 18:26來源：藍天飛行翻譯 作者：航空 點擊：次
|
安定面 stabilizer 1) 操縱鋼索張力重復檢測低 。Control cable tension was low by checked repeatedly 2) 無法配平。Can not be trimed 3) 安定面表面移動過多。Too much movement of stabilizer surface 安定面配平 stabilizer trim 1) 飛行中不能保持位置。Can not hold position in flight 2) 不能靈活移動。Can not move freely 3) 只能低速移動。Moved with slow speed only 4) 非計劃機頭向上。Unscheduled nose up 5) 自動駕駛接通 CMD A/B。autopilot engaged in CMD A/B 6) 配平輪慣性轉動超過…… 。Wheel coasted more than…… 7) 安定面配平電門在向下/上配平時不工作。Stabilizer trim switches can not work during triming down/up. 8) 機身左側平尾處有液壓油. The L/H horizontal stabilizer of the fuselage has hydraulic fluid. 9) 安定面螺桿 Lubricate stabilizer jackscrew潤滑 10) 功能測試次級安定面配平制動器 Do a functional test of secondary stabilizer trim brake ATA56 窗 1) 因B2677右2＃風檔加溫過熱燈亮，故將B2158右2＃風檔串至B2677右2＃風檔。Exchange the R/H window 2 of B2158 to B2677 because of the “OVHT” light of B2677 is on. 2) 在空中，左5號、右1號風擋處有呲呲聲音，增壓正常。In fight, the L/H No.5 and R/H No.1 sound a noise “chichi”, and pressurization check is normal. 3) AF CHECK發現左二號風擋有裂紋。The L/H window 2 has been found crack in AF check. 4) 更換1號風擋。 Replace left No.1 window。 ATA57 大翼 1) 右大翼（機翼前緣位置）位置燈燈罩距翼尖9CM處燈罩有一處2.7CM的裂紋 There is a 2.7cm-long crack at the forward right wing position cover, which is 9cm away from wing tip. 2) 進行前緣襟翼主滑軌止動塊組件檢查時,機翼固定前緣下翼面的接近蓋板有 多個螺釘無法取下. Several bolts of the access panel below the leading edge could not be removed while inspecting the stop ASSY of the leading flap’s main track. 3) 左大翼前緣4�？p翼后一組止檔塊丟失。A group of stop pads after the L/H wing No.4 slot is missed. 4) 在執行翼身過熱探測系統普查中發現M1762阻值偏低，只有0.5m歐姆.The resistance of the M1762 is too low which is only 0.5m in the wing in body overheats detecting system survey. 5) P46定檢中檢查發現右前緣有鳥擊現象。A bird impact is found at the R/H leading edge at P46 check. 6) 過站檢查飛機右大翼最外層副翼調整片由外到內60CM處下表面有雷擊點。There are thunder striking points on the lower surface of aileron tab. 7) 右大翼漏油,有幾處螺釘不好拆下來.The R/H wing leaks fuel and it is difficult to remove several screws. ATA71 動力裝置 |
